| 1234567891011121314151617181920212223242526272829303132333435363738394041424344454647484950515253545556575859606162636465666768 |
- menu "Hardware Drivers Config"
- config SOC_STM32F767ZI
- bool
- select SOC_SERIES_STM32F7
- select RT_USING_COMPONENTS_INIT
- select RT_USING_USER_MAIN
- select RT_USING_CACHE
- default y
- menu "Onboard Peripheral Drivers"
- config BSP_USING_USB_TO_USART
- bool "Enable USB TO USART (uart3)"
- select BSP_USING_UART3
- default y
-
- config BSP_USING_ETH
- bool "Enable Ethernet"
- select RT_USING_LWIP
- default n
- if BSP_USING_ETH
- choice
- prompt "On-board PHY chip"
- default PHY_USING_LAN8720A
- config PHY_USING_LAN8720A
- bool "LAN8720A"
- config PHY_USING_DM9161CEP
- bool "DM9161CEP"
- endchoice
- endif
-
- endmenu
- menu "On-chip Peripheral Drivers"
- config BSP_USING_GPIO
- bool "Enable GPIO"
- select RT_USING_PIN
- default y
- menuconfig BSP_USING_UART
- bool "Enable UART3"
- default y
- select RT_USING_SERIAL
- if BSP_USING_UART
- config BSP_USING_UART3
- bool "Enable UART3"
- default y
- config BSP_UART3_RX_USING_DMA
- bool "Enable UART3 RX DMA"
- depends on BSP_USING_UART3 && RT_SERIAL_USING_DMA
- default n
- endif
- source "../libraries/HAL_Drivers/Kconfig"
-
- endmenu
- menu "Board extended module Drivers"
- endmenu
-
- endmenu
|
