| 12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152535455565758596061626364656667686970717273747576777879808182838485868788899091929394 |
- menu "Hardware Drivers Config"
- menu "Onboard Peripheral Drivers"
- config BSP_USING_STLINK_TO_USART
- bool "Enable STLINK TO USART (uart3)"
- select BSP_USING_UART
- select BSP_USING_UART3
- default y
- config BSP_USING_DSI
- bool "Enable LCD"
- select BSP_USING_SRAM
- select BSP_USING_GFXMMU
- default n
- menu "Enable Touch"
- config BSP_USING_TOUCH
- bool "Enable Touch drivers"
- select BSP_USING_I2C1
- default n
- if BSP_USING_TOUCH
- config BSP_TOUCH_INT_PIN
- int "Touch interrupt pin"
- default 34
- config BSP_I2C1_NAME
- string "I2C1 Name for Touch"
- default i2c1
- endif
- config TOUCH_IC_FT3X67
- bool "FT3X67"
- depends on BSP_USING_TOUCH
- default n
- endmenu
- endmenu
- menu "On-chip Peripheral Drivers"
- config BSP_USING_GPIO
- bool "Enable GPIO"
- select RT_USING_PIN
- default y
- menuconfig BSP_USING_UART
- bool "Enable UART"
- default y
- select RT_USING_SERIAL
- if BSP_USING_UART
- config BSP_USING_UART3
- bool "Enable UART3"
- default y
- endif
- config BSP_USING_SRAM
- bool "Enable SRAM"
- select BSP_USING_FMC
- default n
- menuconfig BSP_USING_I2C1
- bool "Enable I2C1 BUS (software simulation)"
- default n
- select RT_USING_I2C
- select RT_USING_I2C_BITOPS
- select RT_USING_PIN
- if BSP_USING_I2C1
- config BSP_I2C1_SCL_PIN
- int "i2c1 scl pin number"
- range 1 216
- default 116
- config BSP_I2C1_SDA_PIN
- int "I2C1 sda pin number"
- range 1 216
- default 117
- endif
- config BSP_USING_GFXMMU
- bool
- default n
- config BSP_USING_FMC
- bool
- default n
- source "$BSP_DIR/../libraries/HAL_Drivers/drivers/Kconfig"
- endmenu
- menu "Board extended module Drivers"
- endmenu
- endmenu
|
